MODEL H0579 |
190mm AIR HAMMER KIT |
INSTRUCTION SHEET |
EYE/EAR INJURY HAZARD! Wear safety glasses and hearing protection during use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected 
operation during service!
EXPLOSION HAZARD!
Never exceed 120 PSI!
RESPIRATORY HAZARD! Chiseling produces fine dust. Wear the appropriate protection during use!
Introduction
This 190mm Air Hammer Kit can handle the tough- est of jobs. It requires 90 PSI with a minimum of 4 CFM compressor capacity. Weighs 3.3 lbs.
Figure 1. Model H0579.
Insert the bit by slightly bending the retainer spring out of the way of the cylinder bore and slide the bit in. Relax the retainer spring so the "U" sits in front of the bit flange to hold the bit in place.
Air Hammer MUST have 3-4 drops of oil directly dropped into the air fitting before each use as shown in Figure 2.
Inventory |
| |
A. | Air Hammer | 1 |
B. | Oil Bottle | 1 |
C. Five Piece Bit Set | 1 | |
D. | 1⁄4" NPT Air Fitting | 1 |
E. | Retainer Spring | 1 |
Operation
Thread the retainer spring on the air hammer cylinder.
Figure 2. Lubricating directly into air fitting.
If you need help with your new pneumatic tool, call our Tech Support at: (570)
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8026 PRINTED IN TAIWAN
