Grizzly specifications Installing a Grease Cartridge, To operate your H0580 grease gun

To operate your H0580 grease gun:

1.Connect the grease gun to compressed air regulated at a pressure between 30 and 100 PSI.

Note: For quick connection type air fittings, a 1/4" NPT female plug is needed (sold sepa- rately.)

2..Wipe all fittings clean with a shop towel.

3..Pull grease gun trigger once or twice to purge the coupler of any contaminates or old grease.

4... Push the grease gun coupler onto the fitting to be lubricated.

Note: It is easier to attach the coupler to the fitting at a slight angle. Be sure to center the coupler over the fitting when applying grease.

5..Pull the trigger to inject grease.

6..After lubricating, turn the coupler at a slight angle to release it from the fitting.

NOTICE

Some mechanical systems may only require a small amount of grease, while others require much more.. Understand the lubri- cation requirements of the part you are lubricating.. Failure to follow this instruction can damage seals or under-lubricate parts, causing costly damage..

Installing a Grease Cartridge

To install a grease cartridge, the follower assem- bly must be fully withdrawn, allowing room for the new cartridge.

To properly load a new grease cartridge:

1..DISCONNECT THE TOOL FROM THE AIR SUPPLY!

2..Pull the follower rod back until it is fully extended; the locking tab will automatically hold it in place (Figure 4).

Follower Rod

Locking Tab

Figure 4.. The follower rod and locking tab

3..Remove the head assembly (Figure 1) from the cartridge tube.

4..If an empty grease cartridge is in the gun, remove it by carefully pushing the locking tab and allowing the follower rod to slowly move into the cartridge tube.

5..After ejecting the used grease cartridge, pull the follower rod back until it is fully extended, and allow the locking tab to hold it in place (Figure 4).

6..Insert the new greaes cartridge into the car- tridge tube according to the instructions on the grease cartridge.

7..Securely fasten the head assembly to the cartridge tube and release the follower rod by pushing on the locking tab.

8.Push the follower rod in as far as possible.

-2- H0580 Pneumatic Grease Gun