MODEL H0592 |
7" ANGLE SANDER |
INSTRUCTION SHEET |
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to prevent serious personal
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected 
operation during service.
EXPLOSION HAZARD!
Never exceed 120 PSI.
Introduction
An excellent air sander that has a free speed of 4,500 RPM. Requires 90 PSI and consumes 12 CFM. Spindle thread nut is 5⁄8" x 11 UNC. Weighs 6.5 lbs. Pad size is 7". Air inlet is 1/4" NPT.
Inventory |
| |
A. | Air Sander | 1 |
B. | 1 | |
C. | Flat Wrench 19mm | 1 |
D. | 7” Sanding Pad | 1 |
E. | Lock Nut | 1 |
F. | Handle | 1 |
Figure 1. Model H0592.
Quick | Quick | Lubricator | |
Connector | Connector | Regulator | |
Your |
|
| Air |
Tool |
|
| Compressor |
Quick |
|
|
|
Coupler |
| Quick |
|
| Air Hose | Filter | |
| Coupler | ||
|
| ||
Figure 2. Installing your tool.
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/ regulator as shown in Figure 2. Otherwise, lubri- cate daily with a couple drops of pneumatic tool oil directly into the air fitting as shown in Figure 3.
Figure 3. Lubricating directly into air fitting.
If you need help with your new pneumatic tool, call our Tech Support at: (570)
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TR7971 PRINTED IN TAIWAN
