Grizzly H3029 instruction sheet Assembly Instructions

ASSEMBLY INSTRUCTIONS

FRONT AXLE ASSEMBLY

1.With the bed turned upside down, fasten the front and rear axles (Figure 2) to the bed with four M8-1.25 x 20 hex bolts, flat washers, and lock nuts. The hex nuts should face up and the front axle steering supports should point toward the rear of the cart.

Steering

Supports

Front Axle	Rear Axle
Assembly	Assembly

Figure 2. Axles mounted to the bed.

2.Place the steering bracket (Figure 3) over the front axle so the longer length of the bracket lays over the top of the axle, insert the front axle stud (Figure 3) through the short length of the bracket, and secure with a cotter pin.

	Long
	Length	Steering
		Bracket
Steering		Axle
Bar
		Short
Steering	Front
		Length
Brace	Axle Stud

3.Fasten the steering brace to the bed with two M8-1.25 x 20 hex bolts, flat washers, and lock nuts.

4.Insert an M6-1 x 20 hex bolt through the steering brace, the axle, and the steering bracket and secure with a flat washer and lock nut.

5.Place the steering bar under the steering supports and steering bracket, and secure with M6-1 x 16 hex bolts, flat washers, and lock nuts as shown in Figure 3.

REAR AXLE ASSEMBLY & WHEELS

1.Slide a rear axle brace onto each rear axle and bolt the ends of the braces to the bed using the remaining M8-1.25 x 20 hex bolts, flat washers, and lock nuts, as shown in the

Parts Breakdown.

2.Slide a tire and a 16mm flat washer over each axle with the tire valve stems facing outward. Insert a cotter pin into each axle and spread.

PULL HANDLE & WOOD SIDES

1.Insert the end of the pull handle through the plastic coupling and mount these to the front of the steering bracket with a slot head screw, flat washer, and lock nut.

2.Turn the cart over and fasten the metal brackets to the outside edge of the cart with M6-1 x 16 flat head screws, flat washers, and acorn nuts.

3.Slide the front, rear, and side panels into the brackets.

If you need additional help with this procedure, call our Service Department at: (570) 546-9663.

Figure 3. Front axle assembly.