MODEL H3172 |
MINI DIE GRINDER KIT |
INSTRUCTION SHEET |
EYE/EAR INJURY HAZARD! Wear safety glasses and hearing protection during use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected 
operation during service!
EXPLOSION HAZARD! Never exceed 90 PSI!
Only use stones rated for
21,000 RPM or less!
RESPIRATORY HAZARD! Grinding produces fine dust. Wear the appropriate protection during use!
Figure 1. Model H3172.
Die Grinder MUST have 3-4 drops of oil directly dropped into the air fitting before each use as shown in Figure 2.
Introduction
This mini air die grinder kit with 1⁄4" NPT inlet includes 1⁄8" and 1⁄4" collets, collet wrenches and five grinding stones. Grinding stones include ball, cylindrical and tapered shapes. It has a no load speed of 21,000 RPM.
Inventory |
| |
A. | Die Grinder | 1 |
B. | Wrenches | 2 |
C. | Collet | 1 |
D. | Stones | 5 |
Figure 2. Lubricating directly into air fitting.
If you need help with your new pneumatic tool, call our Tech Support at: (570)
Operation
Insert your 1⁄4" shank into the collet. Using the two wrenches, secure tool by tightening the collet nut against the rotor shaft. To change collets, remove the collet nut, replace collet and tighten collet nut.
COPYRIGHT © MARCH, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8029 PRINTED IN CHINA
