Grizzly H3236 manual

MODEL H3236
SLOW SPEED KIT
For G4176
INSTRUCTIONS
4. Removethechain coverandthe two14mm
hexnutssecuringthePositionA&Bchange
gearstotheshafts.
5. SwaptherequiredgearsinPositionsA&B
showninFigure 2.
6. Reinstallthehexnutsandthechaincover.
TheModelG4176powerfeederis equippedwith
twosetsofchangegearsthatprovidefourdifferent
feedratesof20, 26,33,and 43feetperminute.
The Model H3236 Slow Speed Kit provides
twoadditional feed rates of 13 and 62 feet per
minute.Usethetablebelow(Figure 1)andthese
instructionstoinstalltherequiredchangegearsto
getyourdesiredfeedrate.
Always disconnect power
to th e machin e befo re
performing maintenance.
Failure to do this may
result in serious person-
al in jury.
Figure 2.Changegearlocations.
ChangeGear
PositionA
ChangeGear
PositionB
ChangeGear
Chart
To change your power feeder feed rate:
1. MovetheswitchtotheOFFposition.
2. DISCONNECT THE POWER FEEDER
FROMPOWER!
3. Refertothechange geartableontheinside
of the chain cover (Figure 2)or the table
in Figure 1 to find the gear combination
requiredforyourchosenfeedrate.
If you need help with your new item, call our Tech
Support at: (570) 546-9663.
COPyRIGHT©JULy,2008ByGRIzzLyINDUSTRIaL,INC.
WARNING: NO PORTION OF THESE INSTRUCTION S MAy BE REPRODUCED IN ANy S HAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF GRIzz Ly INDUSTRIAL, INC.
#CR10849PRINTEDINTaIWaN
Model H3236 Slow Speed Kit Gears:
A,16Tooth+B,34Tooth=13 Ft(4M)/
PerMin
A,34Tooth+B,16Tooth=62 Ft(19M)/
PerMin
OriginalEquipmentChangeGears:
A,20Tooth+B,30Tooth=20 Ft(6M)/
PerMin
A,30Tooth+B,20Tooth=43 Ft(13M)/
PerMin
OriginalEquipmentaccessoryChangeGears:
A,24Tooth+B,26Tooth=26 Ft(8M)/
PerMin
A,26Tooth+B,24Tooth=33 Ft(10M)/
PerMin
Change Gear and Feed Rate Chart
Figure 1.Changegeartable.