Model H5528 & H5529 |
Medium Duty Spray Gun |
This gravity feed spray gun includes a 1.4mm nozzle, a durable 600cc cup, an air adjust valve, and a chrome finish for easy
SETUP
1.Thread the paint reservoir onto the top of the spray gun and attach the airline with a 1Ú4" NPT fitting.
2.Adjust the air pressure so that the gun is supplied with 30 PSI.
Nozzle |
|
|
| Paint | |
Control |
| Reservoir |
|
|
|
Fluid
Control
Pattern
Control
Air Flow
Control 
Figure 1. Spray gun controls.
ADJUSTMENTS
Identify the spray gun controls in Figure 1 and adjust in the following order:
1.Fluid ControlÑAdjusts how far back the trigger can be pulled, which affects the volume of finish released.
2.Air Flow ControlÑAdjusts the volume of air that mixes with the finish, and thus, increases or decreases the finish atomization.
3.Pattern ControlÑVariably adjusts the spray pattern from round to a wide fan.
4.Nozzle ControlÑAdjusts the spray pattern from vertical to horizontal.
OPERATION
Hold the sprayer 6"Ð8" from the workpiece, and keep the spray gun perpendicular to the workpiece during strokes. DO NOT pivot your wrist when spraying! Feather strokes by starting your stroke before triggering the spray gun, and releasing the trigger before finishing the stroke. Overlap strokes by 50%
MAINTENANCE
1.Clean the spray gun passages after each use by spraying a small amount of thinner. DO NOT immerse the spray gun in the thinner.
2.To avoid internal damage, use only the included brush soaked with thinner when cleaning inside the spray gun.
3.Regularly clean the filter between the reservoir and the spray gun.
4.Trigger, control valves, and springs should be lubricated periodically.
EXPLOSION HAZARD! Do not spray flammable fluids near an open flame or ignition source.
RESPIRATORY HAZARD! Always wear a respirator rated for paint and solvent vapors when operating the H5528 and H5529 Spray Guns.
If you need additional help with these procedures, call our service department at: (570)
COPYRIGHT © SEPTEMBER, 2003 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
PRINTED IN CHINA
