MODEL H6138 |
1⁄2" AIR IMPACT |
WRENCH |
INSTRUCTION SHEET |
EYE INJURY HAZARD! | |||
Always wear safety glasses | |||
during | use | to | prevent |
serious personal injury! | |||
INJURY HAZARD! | |||
Always disconnect tool from | |||
air to | prevent | unexpected | |
operation during service! | |||
EXPLOSION HAZARD! | |||
Never exceed 120 PSI! | |||
Introduction
1⁄2" drive accepts all 1⁄2" standard and metric sock- ets. Features pistol grip with trigger switch, for- ward and reverse switch, 4 clutch settings, rubber bumpers for protection against normal garage use and a 1⁄4" NPT male quick connect fitting. Sockets not included.
Figure 1. Model H6138.
Quick | Quick | Lubricator | |
Connector | Connector | Regulator | |
Your |
|
| Air |
Tool |
|
| Compressor |
Quick |
|
|
|
Coupler |
| Quick |
|
| Air Hose | Filter | |
| Coupler | ||
|
| ||
Inventory |
| |
A. | Air Impact Wrench | 1 |
B. | 1⁄4" NPT Quick Connect Fitting (male) | 1 |
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/ regulator as shown in Figure 2. Otherwise, lubri- cate daily with a couple drops of pneumatic tool oil directly into the air fitting as shown in Figure 3.
Figure 2. Installing your tool.
Figure 3. Lubricating directly into air fitting.
If you need help with your new pneumatic tool, call our Tech Support at: (570)
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8007 PRINTED IN CHINA
