
3.Place a log on the cradle between the wedge and piston rod.
4.Use the advance pump handle (Figure 1) to quickly move the piston rod until it is close to the log. Then use the splitting pump handle (Figure 1) to split the log.
5.Turn the release knob counterclockwise to return the piston rod to the cylinder, turn the knob clockwise to start over, then remove the split pieces.
Storage
Store the log splitter in a dry location with the release knob open, to relieve hydraulic pressure.
Maintenance
Wipe down the log splitter to remove tree sap or dirt. Occasionally you may need to add hydraulic oil to maximize performance.
To add oil:
1.Fully extend the piston rod.
2.Remove the oil seal (Figure 3).
Oil Seal
Figure 3. Oil Seal.
3.Turn the release knob counterclockwise to expel air out of the oil seal hole.
4.Add hydraulic oil until the cylinder is 3⁄4 full.
5.Replace the oil seal.
If you need additional help with this procedure, call our service department at: (570)