6.Put on safety goggles, rubber gloves, and rinse these parts thoroughly in solvent, then dry with compressed air or let air dry.
Note: If the small holes in the atomizing cap become blocked, soak in clean solvent. If the blockage still exists, clear the blockage with a small needle, tak- ing great care to not enlarge or damage the hole. Damage to the hole will create a disrupted spray pattern.
7.Use an old tooth brush with solvent to clean the inner orifice and other hard to reach areas on the outside of the spray gun body.
8.Wipe the gun body with a lint free shop towel to dry.
Lubrication
Lubricate the following areas with spray gun lube after cleaning:
A.Atomizing Cap Threads and Gasket
B.Pattern Control Knob
C.Fluid Control Knob
D.Reservoir Quick Release Lever
E.Reservoir Gasket
F.Trigger Pin
After each cleaning, apply a thin film of petroleum jelly to the needle spring before reassembling.
B
A
C
FD
E
Figure 15. Lubrication points.
A | B |
| |
F | C |
| |
E | D |
Figure 16. Lubrication points.
Model H6331 HVHP Spray Gun Set |
