Grizzly H6441, H6440 specifications Replacing Bulb

Replacing Bulb

1.Turn the lamp OFF, unplug it from the power source, then allow it to cool.

2.Remove the six flat head screws from the cover plate on the back of the lamp housing, as shown in Figure 2.

Rubber Gasket &

Retaining PlateBack Cover

& Flat Head

Screws

Figure 2. Back cover plate removed from the

lamp housing.

3.Carefully remove the back cover, rubber gasket, and the retaining plate from the lamp housing.

4.Identify the bulb assembly connection and retaining cap inside the lamp housing, as shown in Figure 3.

Bulb Assembly

Retaining Cap

Bulb Connection &

Insulation Sleeve

Figure 3. Bulb assembly connection and

retaining cap.

5.To remove the retaining cap and bulb assem- bly from the reflective cone, push the cap down as you twist it counterclockwise.

Note: Notice how the compression spring is mounted on the inside flanges of the retaining cap.

6.Slide the insulation sleeve surrounding the bulb assembly connection down the wire, then carefully pull the connection apart, as shown in Figure 4.

Insulation Sleeve

Bulb Assembly

Retaining Cap & Spring

Figure 4. Bulb assembly and retaining cap

removed from the lamp housing.

7.Re-connect the new bulb assembly, slide the insulation over the connection area, then re- install the parts in the reverse order they were removed.

Like all high intensity lamps there is potential danger when operating this lamp. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this lamp with respect and caution to decrease the risk of operator injury. If normal safety pre- cautions are overlooked or ignored, serious personal injury may occur.

If you need help with your new halogen lamp, call our Tech Support at: (570) 546-9663.

-2- H6440/H6441 Halogen Lamp