Using the LED Gooseneck Work Light
The LED gooseneck work light is a hands- free solution to illuminating low light opera- tions.
To use the LED gooseneck work light:
1. DISCONNECT THE BATTERY CHARGER FROM THE AC/DC ADAPTER!
2.Mount a charged 7.2 NiCad battery into the battery charger (see Figure 2).
3.Use the small switch on the battery charger to turn the LED gooseneck work light ON and OFF.
LED Light
Switch
Figure 2. LED gooseneck work light with
battery installed.
Installing Bits
The Model H8124 uses bits and cutters with a 3⁄32" or a 1⁄8" diameter shaft. See the Grizzly catalog or www.grizzly.com for a complete listing of available bits and accessories.
to install a bit
DO NOT use bits or cutters with a cutting diameter larger than 1". The bit or cutter could break apart under the stresses of high speed use caus- ing serious personal injury.
To install a bit:
1.REMOVE THE BATTERY FROM THE GRINDER!
2.Depress the collet lock (see Figure 3) and loosen the collet nut with the collet wrench. The collet lock will engage as the collet rotates.
Note: It is not necessary to com- pletely remove the collet nut from the shaft unless you are also changing the collet.
Collet Nut
Collet Lock
Figure 3. Collet lock.
3.Insert at least 1⁄2" of the bit into the collet.
4.Hand tighten the collet nut while depressing the collet lock. Then, use the collet wrench to tighten the collet nut an additional 1⁄3 turn.
Model H8124 7.2V Mini Grinder Kit |
