Grizzly H8210 instruction manual Daily Maintenance, To use the air hammer

EYE INJURY

HAZARD!

Wear protective

equipment when

using this tool.

To use the air hammer:

1.Attach the 1/4" NPT male quick connect fitting to the air inlet plug.

2.Attach the air hammer to an air supply set at 90 PSI.

3.Hold the air hammer securely.

4.Use the trigger to START and STOP the air hammer.

5.To avoid accidental starting, discon- nect air hammer from air supply when not in use.

EAR/LUNG

INJURY HAZARD! Wear protective equipment when using this tool.

ACCIDENTAL

START HAZARD! Disconnect before service or tool changes.

AIR PRESSURE

HAZARD!

Never exceed max

PSI rating for tool.

Daily Maintenance

The air hammer MUST have 2-6 drops of oil directly dropped into the air fitting before each use. In addition, we recommend using an in-line filter, lubricator, and regulator as shown in Figure 4.

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Figure 4. Installed filter lubricator regulator.

These procedures should be done after each use:

• Wipe the motor housing and tool bits with a dry cloth, or blow off the dust and debris with compressed air.

• Check for damage to tooling, hoses, housing or other accessories. Promptly fix if damage is found before using again.

Model H8210 10 Piece Air Hammer Kit -5-