Grizzly H8233 owner manual Cleaning & Lubrication, CleaningLubricating

CLEANING & LUBRICATION

CleaningLubricating

Use non-flammable solvent to clean the nose assembly of the nailer/stapler. Always be sure that the tool is dry before using it again.

Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer/stapler; this may result in leaks and damage to the nailer and the air cou- plings.

Never clean this tool with gasoline or other flammable liquids. Vapors in the tool may ignite, causing the tool to explode. Ignoring this warning may lead to serious personal injury or even death!

Standard pneumatic tool oil has been included with your new Grizzly nailer/sta- pler to help maintain its useful life. Place two to six drops of oil in the tool air inlet (as shown in Figure 14) before every use, or after 2 hours of continuous use.

Wipe off any excess oil near the exhaust port to avoid dust build-up. When the oil that was included with the nailer/stapler has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

Another option to manual oiling would be to install a lubricator in your air compres- sor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer/stapler will not be necessary. Just make sure there is always oil in the lubricator.

Figure 14. Lubricating nailer/stapler via

air inlet.

Model H8233 3-Piece Framing/Brad Nailer & Stapler Kit -15-