Grizzly h8234 OperationS, Loading, Operating, To load your nailer, To operate your nailer

OperationS

Loading

When replacing nails in your Model H8234, follow these guidelines:

Nail Size	1⁄8" Shank Diameter
Nail Strip Angle	28º Clipped Head
Length	2"–31⁄2"
Magazine Capacity	2 x 25 Nails

To load your nailer:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Grip the nailer firmly, and pull the magazine pusher back until the catch lever engages, as shown in Figure 3.

Pusher

Figure 3. Sliding magazine pusher back

and engaging catch lever.

3.Insert a strip of nails, pointed-end down, into the magazine as shown in

Figure 4.

Figure 4. Loading nails into magazine.

4.Tilt the nailer to slide the nails all the way down to the nose.

5.With one hand on the magazine pusher for control, release the magazine catch and slowly allow the pusher to press against the nails.

Operating

If you have not read the safety instruc- tions in this manual, do not operate the nailer.

Before you operate your nailer, place five to six drops of the included oil into the quick connect fitting where the nailer con- nects to the air supply.

To operate your nailer:

1.Connect the air supply to the quick con- nect fitting.

2.To test for proper nail penetration, hold the nailer perpendicular to the surface of a piece of clean scrap wood that is thick enough for the length of nails you have loaded.

Model H8234  28° Framing Nailer -9-