MODEL T10113UNIVERSAL OVERARM BLADE GUARD

INSTRUCTIONS

Copyright © NoVEMBEr, 2008 By grizzly iNdustrial, iNC.
WARNING: NO pORTION Of ThIS MANUAL MAy BE REpRODUCE D IN ANy ShApE
OR fORM WIThOUT ThE WRITTEN AppROVAL Of GRIzz Ly INDUSTRIAL, INC.
#ts11340 priNtEd iN taiWaN
To reduce the risk of serious injury when
using this blade guard:
1. RIVING KNIfE. Before using this blade
guard, your table saw Must have the riv-
ing knife properly installed.
2. BLADE GUARD hEIGhT. always properly
adjust the blade guard height so that the
guard wheels rest on the table and the
guard will not interfere with the workpiece
as it passes underneath.
3. TABLE SAW OWNER'S MANUAL. read
and understand the table saw owner's
manual and always follow all safety pre-
cautions and instructions for your table saw
during operation.
4. DUST COLLECTION SySTEM. always
use a dust collection system with this blade
guard that is adequate for your operation.
5. ADJUSTMENTS, MAINTE NANCE, OR
SERVICE. always disconnect the table
saw from power before you perform any
adjustments, maintenance, or service to
this blade guard or your table saw.
6. TABLE SAW ATTAChMENT. always make
sure the blade guard assembly is firmly
attached to the table saw so that the blade
guard will not move away from its correct
and safe position during operation.

Introduction

the Model t10113 universal overar m Blade
guard is designed to fit most table saws with a
stable adjustable base and a 3" dust collection
boom that can rotate 90° and extend from 39" to
68" over the saw blade.

Inventory

after rem oving the contents of the shipping
package, lay them out and refer to the parts
Breakdown and listing on page 3 to inventory the
components.
If you need help with your new Universal Overarm
Blade Guard, call our Tech Support at: (570) 546-
9663.
figure 1. Model t10113 identification.
Blade
guard
dust
Collection
Boom
table saw
Connection
Bracket
4" dust hose here