Grizzly manual Model T10117, BIG-MOUTH Dust, Hood w/STAND, Instructions

	MODEL T10117
	BIG-MOUTH DUST
	HOOD w/STAND
	INSTRUCTIONS
Introduction	Assembly

The Model T10117 Big-Mouth Dust Hood provides a method of effective dust collection for machines that do not come equipped with dust ports, or for additional dust collection when needed. The dust hood adjusts vertically from 29" to 49".

4" Dust Hose

Connected Here

Adjustable

Angle Pivot

Bracket

Dust Hood	Adjustable Height
	Vertical Supports

Figure 1. Model T10117 identification.

Inventory

After removing the contents of the shipping package, lay them out and refer to the Parts Breakdown on the back page to inventory the components.

If you need help with your new dust hood, call our Tech Support at: (570) 546-9663.

Refer to Figure 1 and the Parts Breakdown illustration to aid you in the following assembly procedure.

Tools Needed	Qty
Wrench or Socket 10, 14mm	1 Each
To assemble your dust hood:

1.Thread the four foot pads into the base.

2.Secure the vertical support assembly onto the base by threading the 3⁄8"-16 x 1" hex bolt, lock washer, and flat washer through the bottom of the base and into the support assembly.

3.Install the angle pivot bracket onto the top of the vertical support assembly with the two 1⁄4"-20 x 1⁄2" hex bolts.

4.Use the 3⁄8"-16 x 1 1⁄2" knob to install the dust tube onto the angle pivot bracket.

5.Slide the hood mounting tube onto the dust tube and secure it in place with one of the 1⁄4"-20 x 3⁄8" knobs.

6.Insert the dust hood into the mounting tube, then secure it in place with the remaining 1⁄4"-20 x 3⁄8" knob and wing nut.

Operation

Adjust the angle pivot and vertical support assem- bly so that the hood is positioned close enough to the operation to be effective without interfer- ing with it. Then, securely clamp a 4" dust hose between the hood assembly and your dust collec- tion system.