MODEL T10121 |
MAGNETIC |
MISTING UNIT |
INSTRUCTIONS |
Operation |
|
|
| 1. | Close the air flow and misting valves, and use | |
Damage to your eyes, lungs, and skin could | the knob to apply the magnet and clamp the | ||||
result from using misting unit without | base to a metal surface (Figure 1). | ||||
protective gear, such as safety | glasses, |
| |||
a respirator, and rubber gloves. | 2. | Connect the air inlet to a | |||
|
|
|
|
| source, point the atomizing tip at the cutter, |
|
|
|
|
| |
|
|
|
|
| and insert the suction tube into the coolant. |
|
|
| 3. | Use the air valve and the misting valve to | |
|
|
|
|
| control the misting spray so it can barely be |
|
|
|
|
| seen. Flooding is not required. |
POISON HAZARD!
Use personal protection equipment when handling coolants and using this tool. Follow federal, state, coolant manufacturer requirements to properly dispose of coolants.
Specifications
• | Distribution Tube Overall Length | ........... 193⁄4" | ||
• | Atomizing Tip Orifice ID | 2mm | ||
• | Construction | Steel, Brass, Aluminum | ||
• | Suction Tube |
| 3⁄32" x 80" | |
• | Suction Tube Filter Type | Brass Wafer | ||
• | Air Valve Type | Lever and Ball | ||
• | Misting Valve Type | Knob and Needle | ||
• | Fitting Type | |||
• | Recommended Air Supply | |||
• | Weight |
| 3.74 lbs | |
If you need help with your new misting unit, call our Tech Support at: (570)
| Distribution | |
| Tube | |
Atomizing | Air Inlet | |
| ||
Tip | Air | |
| Valve | |
| Magnetic | |
Misting | Base | |
Control | ||
Valve | ||
| ||
Suction |
| |
Tube | Filter |
Figure 1. Magnetic misting unit inventory and
controls.
Copyright © MAY, 2009 By Grizzly Industrial, Inc.
Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.
#CR11822 printed in TAIWAN.
