Grizzly T10131 specifications Accessories, G2544-Solvent Cleaner & Degreaser

3.Use a straightedge as a gauge and adjust the extension wing up/down until it is flush with the main table above each cap screw, then completely tighten the cap screws.

4.Place the straightedge across the extension wing and main table to make sure that the combined table surface is flat.

—If the outside end of the extension wing tilts down, use a strip of masking tape along the bottom edge of the main table to shim the extension wing up (see Figure

3).

Figure 3. Masking tape location for tilting the

extension table up.

—If the outside end of the extension wing tilts up, use a strip of masking tape along the top edge of the main table to shim the extension wing down (see Figure 4).

Note: After reinstalling the wing, remove all excess masking tape with a razor blade.

5.Align the mounting holes on the support plate and the bottom of the extension table, then fasten with four M8-1.25 x 12 hex bolts and flat washers, as shown in Figure 5.

Support

Plate

4x

Knob

Foot

Figure 5. Support installed.

6.Loosen the knob, slide the lower section of the support down and tilt the foot so it is flush with the floor, then tighten the knob.

Do not place workpieces heavier than 100 lbs. on this extension table! Doing so may cause the table to fail, increasing your risk of serious personal injury.

If you need help with your new extension table, call our Tech Support at: (570) 546-9663.

Accessories

G2544—Solvent Cleaner & Degreaser

A great product for removing the waxy shipping grease from your machine during clean up.

		Figure 6. Cleaner/degreaser available from
Figure 4. Masking tape location for adjusting the
				Grizzly.
-2-	extension wing down.		T10131 Bandsaw Extension Table