
| MODEL T10252 |
| DUST PORT |
| FOR G1183/G1276 |
| INSTRUCTIONS |
Introduction | Dust Collection |
The Model T10252 Dust Port helps capture dust from the disc sander on the G1183/G1276 Combination Sanders that were manufactured before August, 2010.
NOTICE
The installation of the dust port requires that you remove the lower disc guard from the sander and modify it. Read through this entire document before beginning the installation procedure on the next page.
The included dust collection hose assembly has a 2⁜1⁄2" adapter for connection to your dust collection system.
DO NOT operate the Model G1183/G1276 sander without an adequate dust collec- tion system. This sander creates substan- tial amounts of wood dust while operating. Failure to use an adequate dust collection system can result in short and
Shipping Inventory (Figure 1)
A. | Dust Chute | 1 |
B. | Phillips Head Screws | 2 |
C. | Hose Clamps 1⁜1⁄2" | 2 |
D. | Dust Hose 1⁜1⁄2" x 10" | 1 |
E. | Hose Adapter 2⁜1⁄2" x 1⁜1⁄2" | 1 |
F. | Cover Plate | 1 |
G. | Flat Washers 5⁄16" | 2 |
H. | Hex Bolts | 2 |
A | E |
| |
B | C |
F |
|
G | D |
H |
|
Figure 1. Model T10252 shipping inventory.
Recommended CFM at Dust Port: 150 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust collector,
(2)hose type and length between the dust col- lector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to cal- culate these variables is beyond the scope of this manual. Consult an expert or purchase a good dust collection
If you need help with your dust port, call our Tech Support at: (570)
Copyright © NOVEMBER, 2010 By Grizzly Industrial, Inc.
Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.
#TS13350 printed in TAIWAN