Grizzly T10268, T10275, T10264, T10274 manual Introduction, Inventory, Setting the Blade

MODEL T10264/T10268/

T10274/T10275

HAND PLANE

INSTRUCTIONS

Introduction

The wood hand plane is a simple tool that is designed to shape wood or clean up edges for joinery.

Your hand plane features a hardwood body, a steel blade (also called an iron) and a brass frog with a knurled lock knob for locking the blade in place. To achieve the best results when using your specific type of hand plane, we recommend reading books and magazines, and researching the internet.

Inventory
A.	Plane	1
B.	Blade	1
C.	Frog	1

2.Orient the bevel of the blade for the type of planing you intend, insert the blade below the frog, then set the blade below the sole of the plane (see Figure 1) for the initial cut.

3.Tighten the knurled lock knob to secure the blade.

4.Verify that the blade is parallel with the sole— so an even amount of the blade protrudes from one side to the other.

—If the blade is not parallel to the sole, loosen the lock knob and adjust the blade as needed. One side will cut more than the other if the blade is not parallel to the sole.

Setting the Blade

1.Insert the frog beveled-edge down into the throat until it stops on its own or until the groove in the top of the frog engages the pin, as shown in Figure 1.

AdX`@cdW	;gd\
I]gdVi
E^c	7aVYZ
7ZkZa	HdaZ

Figure 1. Example of blade secured with frog

and lock knob.

To reduce the risk of injury when using this tool:

•Use care when handling the plane blade. It is sharp and can cause lacerations.

•Protect your eyes from flying chips by wearing safety glasses.

•Make sure the workpiece is properly secured.

•Use both hands to guide the plane over the workpiece.

•Keep the plane away from children.

Copyright © OCTOBER, 2010 By Grizzly Industrial, Inc.

Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.

#BL13383 printed in CHINA