Grizzly T20568 owner manual Compressed Air System

Compressed Air

System

The Model T20568 is designed to be oper- ated at 60-100 PSI using clean, dry, regu- lated, compressed air. Do not exceed the 120 PSI maximum operating pres- sure for your model.

Before using your new nailer, regulate the air pressure on your air compressor to the minimum PSI for your model.

An in-line filter/lubricator/regulator unit, depicted in Figure 2, can be installed and should be located as close to the nailer as possible.

This filter/lubricator/regulator unit will pro- tect your tool from damaging water build- up, allow you to adjust and maintain con- stant air pressure to your tool, and save you the inconvenience of manually lubri- cating your tool every time you use it.

Exceeding the maximum permissible operating pressure may cause the nailer to explode, blowing metal frag- ments in all directions. To protect yourself from serious personal injury, DO NOT allow your air compressor to exceed the recommended pressure when connected to this nailer!

Check the current Grizzly catalog for avail- ability of this unit. If you plan on install- ing a filter/lubricator/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Figure 2. Typical filter/lubricator/regulator installation order.

-6- T20568 11⁄4" Brad Nailer