Grizzly T21319 instruction sheet Basic Bending Operations, Clamp Adjustment on this

Adjusting Nuts

Clamping Set Screw

Figure 4. Clamp installation.

4.Screw the two breaker bar levers into the breaker bar holes, as shown in Figure 5.

Figure 5. Breaker bar lever installation.

The bending brake MUST be clamped or secured to a workbench before being used. Failure to do so can lead to personal injury or machine damage!

Basic Bending Operations

1.Open the bending brake and place the work- piece beneath the clamping angle.

2.Close the clamp assemblies until they lock. If the workpiece is to thick or too thin for the clamps, adjust the clamps according to

Clamp Adjustment on this page.

3.When the workpiece is secured in the bend- ing brake, lift the breaker bar levers to form the desired angle.

Clamp Adjustment

1.Without turning the clamping set screw, turn the adjusting nuts clockwise to adjust for thicker workpieces and counterclockwise to adjust for thinner workpieces. Adjust each clamp an equal amount.

T21319 Breakdown and Parts List

1	3
2	7	6	5
5			10
		3
8
4			15

11

EYE INJURY

HAZARD!

Always wear safety

glasses when using

this machine.

21

MODEL H2788 24" BENDING BRAKE

Specifications

Max. Workpiece Thickness: 18 Ga. To reduce the risk of serious personal injury when using this
Max. Bend: 145°	machine:
Max. Workpiece Width: 27-1/2"	1.	Read and understand the manual before starting.
Weight: 60 lbs.	2.	Always wear eye protection.
	3.	Wear heavy leather gloves when handling sheet metal.
	4.	Do not exceed the rated capacity of this machine.

5.Do not use a breaker bar to gain leverage.

6.Always firmly clamp workpiece before bending.

22

16

PINCH

HAZARD!

Keep hands away

from clamp area

when clamping or

bending.

23

14	13	24	18	20
		17			19

REF PART #		DESCRIPTION
1	PT21319001	CLAMP
2	PSS39M	SET SCREW M10-1.5 X 50
3	PN05M	HEX NUT M16-1.5
4	PB01M	HEX BOLT M10-1.5 X 30
5	PN02M	HEX NUT M10-1.5
6	PLW06M	LOCK WASHER 10MM
7	PT21319007	COLLAR
8	PT21319008	SPECIAL SET SCREW M10-1.5 X 90
10	PT21319010	CLAMPING ANGLE
11	PT21319011	CLAMP MOUNTING PLATE
13	PT21319013	PIVOT PIN 16 X 50

REF	PART #	DESCRIPTION
14	PT21319014	FLANGE BEARING
15	PT21319015	BASE
16	PT21319016	BREAKER BAR
17	PT21319017	THREADED LEVER M20-1.75
18	PT21319018	BREAKER ANGLE
19	PB03M	HEX BOLT M8-1.25 X 16
20	PW01M	FLAT WASHER 8MM
21	PT21319021	PINCH HAZARD WARNING
22	PT21319022	MACHINE ID LABEL
23	PLABEL-11D	SAFETY GLASSES LABEL
24	PPAINT-1	GREEN TOUCH-UP PAINT