OPERATIONS
Loading
When replacing nails in your Model T21347, follow these guidelines:
Gauge: 18
Length:
Capacity: 100
To load your nailer:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Sliding magazine pusher back, as shown in Figure 3, to lock the catch lever in place.
Catch
Lever
Figure 3. Sliding magazine pusher back
and locking catch lever in place.
3.Insert a strip of nails, pointed-end down, into the magazine as shown in
Figure 4.
Figure 4. Loading nails into magazine.
4.Slide the nails all the way down to the nose of the nailer.
5.Push the magazine pusher all the way in until the catch lever locks.
Operating
If you have not read the safety instruc- tions in this manual, do not operate the nailer.
Before you operate your nailer, place five to six drops of the included oil into the quick connect fitting where the nailer con- nects to the air supply.
To operate your nailer:
1.Connect the air supply to the quick con- nect fitting.
2.To test for proper nail penetration, hold the nailer perpendicular to the surface of a piece of clean scrap wood that is thick enough for the length of nails you have loaded.
T21347 2" Nailer Kit |
