Grizzly T23083 instruction manual Using Grinder, Daily Maintenance

EYE INJURY

HAZARD!

Wear protective equipment when using this tool.

Using Grinder

Always test the grinder on a scrap piece of material similar to the workpiece. Trial and error is the best way to determine the ideal setup.

To use the grinder:

1.Make sure the workpiece is securely held in a vise or a similar device that will ensure the workpiece does not unexpectedly move during operation.

2.Attach the grinder to an air supply set at 90 PSI.

3.Hold the grinder securely, turn the grinder ON by depressing the trigger, then ease the grinding wheel against the workpiece with a light, but steady, pressure.

Note: Vary the grinding wheel speed by the pressure used on the trigger.

4.To turn the grinder OFF, release the trigger.

Note: To avoid accidental start up, dis- connect the grinder from the air supply when it is not in use, and replace the protective cap into the air inlet port.

LUNG/EAR INJURY

HAZARD!

Wear protective equipment when using this tool.

ACCIDENTAL START

HAZARD!

Disconnect before

service or tool

changes.

AIR PRESSURE

HAZARD!

Never exceed max

PSI rating for tool.

Daily Maintenance

The angle grinder MUST have 4-5 drops of pneumatic tool oil directly dropped into the air inlet port before and after each use. In addition, add oil after 3–4 hours of continuous use or install an in-line filter, lubricator, and regulator, as shown in Figure 3.

These procedures should be done after each use:

•Wipe the grinding housing with a dry cloth, or blow off the dust and debris with compressed air.

•Check for damage to grinding wheels, hoses, housing, or other accessories.

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Figure 3. Installed filter lubricator

regulator.

T23083 (Mfg Since 11/10) -5-