MODEL T23093 |
INDUSTRIAL |
3⁄8" AIR DRILL |
INSTRUCTIONS |
For questions or help with this product contact Tech Support at (570) |
Introduction
| Thumb Lock |
| & Trigger |
3⁄8" Chuck |
|
| Air Inlet |
Air Flow | 1⁄4" NPT |
| |
Valve |
|
Figure 1. Model T23093.
Inventory |
|
|
Drill w/Chuck | 1 | |
Chuck Key | 1 | |
..... 1 | ||
Bottle for Oil | 1 | |
Specifications |
|
|
Maximum Bit Diameter | 3⁄8" | |
Maximum Free Speed | 18,000 RPM | |
Average Air Consumption | 4 CFM | |
Air Inlet Size | 1⁄4" NPT | |
Air Hose Size Required | 3⁄8" | |
Maximum Air Pressure | 90 PSI |
EYE/EAR INJURY HAZARD! Wear safety glasses and hearing protection during use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected operation during service!
EXPLOSION HAZARD!
Never exceed 90 PSI!
Operation
1.Install the bit into the chuck, then tighten it in place with the chuck key.
2.To keep the moving parts lubricated, remove the air inlet protective cap and add
3.Wrap the threads of the
4.Attach the drill to clean, regulated com- pressed air that is no greater than 90 PSI.
5.Move the thumb lock forward, then press the trigger to start the drill.
6.If necessary, adjust the speed of the drill by adjusting the air flow valve located on the body near the air inlet.
7.When finished, disconnect the drill from the compressed air system.
Copyright © MARCH, 2011 By Grizzly Industrial, Inc.
Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.
#TS13999 printed in CHINA