Groupe SEB USA - T-FAL Astucio Use Of Adjustable Thermostat, Cleaning, Storing The Appliance

USE OF ADJUSTABLE THERMOSTAT

0	1	2	3	4
stop	keep warm /	simmer	fry	seal
	re-heat

Note : You can adjust the thermostat depending on the dishes to be cooked. With smaller quan- tities of food, it may be necessary to reduce the thermostat to a lower number.

CLEANING

• Unplug and leave the appliance to cool.	washer. Scouring powders and
• The body of the appliance and the fixed reflector	scouring pads are not recom-
can be cleaned with a sponge and washing-up liquid.	mended.
Avoid using an abrasive scouring pad.	Note : if food has burned, leave
N.B. : to easily clean the fixed reflector, raise the lif-	the cooking dish to soak a little
table heating element.	while before cleaning.
• The heating element does not require cleaning, but	• NEVER	IMMERSE THE
when cold, it can be rubbed with a dry cloth to remove	APPLIANCE WITH HEATING
any food deposits.	ELEMENT	AND CORD IN
• The cooking dish, the lid, grill plate and the drip	WATER.
tray (depending on model) must be cleaned after
each use with normal washing-up liquid or in a dish-

STORING THE APPLIANCE

So that the appliance does not take too much place in your cupboard, we advise you to stock the different accessories as indicated on the following drawing :

(some accessories are supplied

depending on model)

FOR U.K. USERS ONLY :

ADDITIONAL INFORMATION AND INSTRUCTIONS

WIRING INSTRUCTIONS

WARNING : ALL APPLIANCES MUST BE EARTHED.

IMPORTANT : the wires in this lead are coloured in accordance with the following codes.

Green and Yellow	: Earth	N: Blue	E: Green and
Blue	: Neutral
		or black	yellow or green
Brown	: Live		L: Brown
Connect the Green/Yellow wire to the ter-			or red
minal in the plug marked “E” (or by the			Fit correct
earth symbol) or	coloured Green	and	fuse(13 amp)
Yellow.			Use cable
Connect the Brown wire to the terminal in			gripper
the plug marked “L” or coloured Red.
ENG Connect the Blue wire to the terminal in
the plug marked “N” or coloured Black.

Seek professional advice if you are unsure of the correct procedure for the above.

ABOUT YOUR FACTORY FITTED PLUG

The cord is already fitted with a plug incorporating an appro- priate fuse. If the plug does not fit your socket outlet, see para- graph below. Should you need to replace the fuse in the plug

supplied, an appropriately rated approved BS 1362 fuse must be used (refer to electrical specification for fuse rating).

If the plug supplied does not fit your socket outlet, it should be removed from the mains lead and disposed of safely. The flexible cord insulation should be stripped back as appropria- te and a suitable alternative plug fit- ted. The replacement plug must be equipped with an appropriate fuse. If the plug has external access to the fuse (non-rewirable type plug) please note that the fuse cover is an impor- tant part of the plug. Please ensure that it is always refitted correctly. If you lose this cover, please do not use the plug. You may contact Tefal U.K. Limited for a replacement.