Description
1.Steam control button
2.Iron temperature control slide
3.Iron thermostat light
4.Ultracordsystem(depending on model)
5.Iron rest
6.Illuminated on / off switch
7.Electriccordrewindbutton (depending on model)
8.Power cord storage space
9.Power cord and plug
10.Turbobutton(depending on model)
11.Double protection cover.
12.Carry handle
13.Unlock button on protective cover
14.Removable water tank
15.Removablewatertankhandle
16.Steam generator boiler (in the base unit)
17.
18.Slide storage place for the steam cord
19.
20.
21.Control panel
a.“Water tank empty” light
b.“Autooff” light
c.Restart button
d.
e.“Reset”button
f.“Steam ready” light
g.Steam output control dial
“PROTECTCONCEPT”safetysystem
Your generator is fitted with the “Protect Concept” system:
•Double protection cover.
•Cover automatically locks when it is folded up over the iron - fig.2 and open using the unlocking button - fig.3 .
•Carry handle - fig.1
Preparation
What water may be used ?
•Your iron has been designed to operate using untreated tap water.
•Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your iron. Also do not use boiled, filtered or bottled water.
Filling the water tank
•Pull the cover up over the iron until the protection system automatically locks (you will hear a “click” ) - fig.2
•Remove the water tank by pulling on the handle (at the front of the generator)
– fig.4.
•Fill the tank with water, taking care not to exceed the maximum level – fig.6. and fig.7.
•Slide the tank back into its housing until its “clicks” into place – fig.5.
•Press the unlocking button on the protective cover until you hear a click, and then fold it back on to the generator base unit – fig.3.
Ultracord System (according to model)
•Your iron is equipped with an extension cord system to prevent the cord from dragging over the laundry and creasing it again when ironing. It also keeps the cord out of the way of your hand.
Ironing with the Ultracord system:
-The Ultracord system automatically tips back.
-Each time you put the iron back on its base, the Ultracord system fits into the heel of the iron and opens back up automatically when you use the iron.
Storing the generator:
-Push the connector back in the heel.
-A magnet holds the connector to the heel, making your generator easy to store – fig.8.
26
