Grundig 37 VLC 6110 C Searching for digital terrestrial TV channels manually

Special settings----------------------------------------------------------------------------------------------------------

6Select the line »Scan Typ« with »V« or »Λ« and set the option »DTV« with »<« or »>«.

7Start the scan with »« (red).

–All channel and favourites lists will be

deleted­ and compiled anew.

Note:

7After starting the scan, a security query will appear. Press »« (green) to confirm the option »Yes«.

–The »Reults« menu appears, and the scan for TV channels begins. Depending on the number of television channels received, this can easily take a few minutes.

–The scan is complete as soon as the

»PROGRAM­ TABLE« appears.

Note:

7You can abort the search by pressing »MENU«.

8Press »MENU« to end the setting.

Automatic service update

If this function is activated, possible changes of network operators are updated automatically.

The unit must be located in stand-by mode.

1Open the menu with »MENU«.

2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.

3Select the line »Automatic Service Update« with »V« or »Λ«.

4Select the automatic update with »<« or »>« (»On«).

5Press »MENU« to end setting.

Searching for digital terrestrial TV channels manually

1Open the menu with »MENU«.

2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.

– The »SOURCE SETUP« menu appears.

3Select the line »Source« with »V« or »Λ« and press »OK« to confirm.

Select the option »Air« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.

Caution:

7The antenna power supply (line »Active Antenna Power«) may only be switched on if the antenna is an active indoor antenna with a signal amplifier and it is not already supplied with a voltage via a mains plug (or similar supply). Otherwise you may cause a short circuit and irreparably dam- age your antenna.

4Select the »Active Antenna Power«« with »V« or »Λ«. Switch on the antenna power supply for the antenna with »<« or »>« (»On«).

5Select » Digital Manual Tuning« with »V« or »Λ« and press »OK« to confirm.

– The menu appears.

6Enter the channel number directly with »1 ... 0« and press »OK« to confirm. –After the search is complete, the channels

found are displayed in the »Results« menu.

7Press »MENU« to finish the setting.

ENGLISH ­45