Mounting Instructions
180°
Ceiling
mounted configuration
2 x M6 Grub
Screws
Housing 
body & sunsheild
1.(2 x M6 x40 Soc. Cap hd screws)
4 x M6 x 16 Soc. Hd. Screws
Arrow ‘A’
View on arrow ‘A’
M20 Cable Gland
Wall
mounted configuration
3.
Remove 4 x M6 x 16 Soc. Hd. screws from rear bracket and rotate cast base until desired position of M20 cable gland is acheived. Replace M6 screws and tighten firmly.
to convert the housing from wall mounted to ceiling mounted orientation. Remove 2 off fixings (item1), rotate bracket arm (item2) through 180° and refit item 1. Loosen locking nut (item 3) & position the housing to the desired orientation and
For additional security 2 x M6 grub screws are provided. To gain access to these grub screws, gently prise out the two plastic stop plugs. Then using the 3mm A/F ball allen key (supplied) either one or both of the grub screws can be tightened with the housing. in the desired orientation. To
508 operation manual | Sheet. 5 |
