Replacing and Cleaning the UV-C Bulb & Filter
5.Remove the (2) phillips screws located on each side of the bulb holder and remove the filter.
6.Lift bulb holder from cylinder. Do not touch bulb. If cleaning, insert soft, dry cloth into cylinder and remove. Repeat if necessary. Do not touch bulb with bare hands. Fingerprints may result in reduced performance unless they are removed with an
alcohol pad. Use a soft cloth as a barrier against contact.
7. If NOT replacing the bulb for the first time jump to step
8. If replacing the bulb for the first time, flip bulb holder over so light bulb faces up. There will be a spring located between the bulb cylinders. Squeeze spring tightly towards bulb and pull out of holder and through bulb. Discard spring. Spring is used for shipping purposes only and does not need to be replaced.
8.Grasp the metal collar on the bulb and pull firmly until bulb unplugs from the bulb holder. When inserting new bulb, make sure the bulb snaps and is locked firmly in place. Reassemble by reversing steps
TROUBLESHOOTING GUIDE
PROBLEM | SOLUTION |
Unit doesn't operate. | Check that unit is plugged in. Call |
| Customer Service at 1.866.603.5900. |
|
|
Light flickers. | Bulb burnt out. See Replacing |
| |
|
|
Fan runs but no light. | Bulb burnt out. See Replacing |
| |
|
|
Low air flow. | Check fan setting knob, turn clockwise |
| to high. Replace filter. See Replacing |
| |
|
|
