Guardian Technologies H1600 warranty Problem, Solution, Inside The Body Of The Unit, Water Tank

9. Night Light Feature	10. Water Refill Button	11. Humidity Spout Direction
Press the Night Lamp button at	When the Water Refill button lights	To change the direction of
the top of the unit to illuminate	up it is time to refill the water tank.	the mist turn humidity spout
the night light feature.		as desired.

•Always unplug the unit before servicing it in any way.

•The temperature of the water remaining in the unit after use may be HIGH.

•Do not submerse the unit in water, or allow water to enter the inside of the unit or humidity spout. Only put water into the water tank.

INSIDE THE BODY OF THE UNIT

Pour excess water out of the unit, but do not allow it to enter the spout guide. Wash out the unit with fresh water, using ONLY the cleaning brush and a soft cloth as needed.

OUTER SURFACE OF THE UNIT

Wipe the surface of the unit with a soft, damp cloth if needed.

WATER TANK

If water spots remain in the water tank, wipe the inside with a soft cloth. DO NOT use soap or detergents.

ULTRASONIC DISK

Remove water tank (Fig. 1) and use the enclosed cleaning brush to regularly remove build up and deposits from this area (Fig. 2). Diluted white vinegar will help to prevent this build up.

*Clean the disk with the brush only. No other cleaning tool should be used. Brush only. (Fig. 2)

Fig. 1 Fig. 2

•Fully dry the inside and outside of the unit before storing it.

•DO NOT leave water in the unit.

•Store in a cool, dry place.

PROBLEM	SOLUTION
Water mist and humidity	Power Plug: Unplug and then try again.
	Power Failure: When the power is returned, try again.
are not produced.
	Water Tank Installation: Make sure the water tank is
	correctly attached. Make sure spring on tank
	cap moves freely when pushed.
	Excessive Water: Remove water tank. Empty a
Air blows but water mist	small amount of water from the base of the unit.
is not produced.	The desired humidity is lower than the current
	temperature: Increase the desired humidity.
	Detergent residue in the tank: Wash the tank out
	and try again.
	The surface of the ultrasonic disk is dirty. Clean
Humidity level is low.	with white vinegar.
	The water in the unit is too cold: Replace with cool,
	but not cold water.
	If ultrasonic disk is damaged contact
	Customer Service at 1.866.603.5900.
	It may take 10-15 minutes before warm
Warm humidity is not produced.	humidity is created. The mist may not feel
	warm to the touch.
	Check to see if base of unit feels warm to the touch;
	if so then warm mist is being produced.
	Poor maintenance or dirty water: Clean the product
The humidity has a bad smell.	thoroughly, and fill it with fresh water.
	Hard water will deposit a certain amount of
White dust is forming on	dust. Dust in the air settles because of the
nearby furniture.	added humidity in the room.
	*Use distilled water if this becomes a nuisance.
	Or order a Decalcification Filter (FLTDC)
	by calling 1.866.603.5900 or
	visiting www.guardiantechnologies.com.

E-6 E-7