INSTALLATION INSTRUCTIONS
RS-232 Interface / Serial Printer Port
The hardware in this package provides an
Wire colors from
Bl R G O Bk Y Gy/Wh Br
|
|
|
|
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | |
|
|
|
|
|
| Install crimp pins in matching | |||||||
|
|
|
|
|
| ||||||||
|
|
|
|
|
| the left. |
|
|
|
|
| ||
1 | 2 | 3 | 4 |
| 5 |
|
|
|
|
| |||
| NOTE: Location 9 on | ||||||||||||
6 | 7 | 8 |
| 9 |
| ||||||||
|
|
|
|
|
|
|
|
|
|
Female
Figure 1: Connector
|
|
|
|
|
| Pin | DCE | DTE |
|
|
|
|
|
| 1 | DCD | DCD |
|
|
|
|
|
| 2 | RXD | TXD |
|
|
|
|
|
| |||
5 |
| 4 | 3 | 2 1 | 3 | TXD | RXD | |
9 | 8 | 7 | 6 | 4 | DSR | DTR | ||
|
|
|
|
|
| 5 | GND | GND |
|
|
|
|
|
| |||
|
|
|
|
|
| 6 | DTR | DSR |
|
|
|
|
|
| 7 | RTS | CTS |
|
|
|
|
|
| 8 | CTS | RTS |
Figure 2: Signal Lines (Female
Pin | DCE | DTE | Pin | DCE | DTE |
1 | DCD | DCD | 5 | GND | GND |
2 | RXD | TXD | 6 | DTR | DSR |
3 | TXD | RXD | 7 | RTS | CTS |
4 | DSR | DTR | 8 | CTS | RTS |
Figure 3: Signal Lines: Interface
NOTE: Observe the drawing and the connector used and verify the color codes are equivalent.
Serial Printers:
If your serial printer requires a male 9 or 25 pin connector, you can get a gender changer at an electronics store. Destiny 6100 panel software supports only GND, TXD, and RXD control lines. Some printers require additional control lines. You may need to jumper these control lines in order to use such print- ers. Consult your printer manual for further information.
Signal Lines:
Figure 2 shows the configuration of signal lines in the
Downloaded from - http://www.guardianalarms.net