Haan SI-70 Using the Carpet Glide, What is the Carpet Glide?, To Remove, 3Carpet Glide

7

Tilt handle at a 45º angle. Push and pull slowly across the floor to clean thoroughly.

8

When done, push ON/OFF button.

9

Place unit with Ultra-microfi- ber pad attached onto Floor Protector / Resting Mat. Allow to cool down for five (5) min.

10

When unit has cooled, remove Ultra-microfiber pad. Store unit upright in a dry area.

IMPORTANT: Vibration Sound

While the unit is turned off, air builds up in the water pump line. This is a common occurrence. When the unit is turned on the water pump pushes air out of the line and emits a vibrating sound. This occurs while the unit is heating up and also when the water tank is emptied during use. If the vibration sound persists for more than 60 seconds during heat up, check to make sure the water tank is assembled correctly.

IMPORTANT

Always empty the water tank once you have finished using your Floor Sanitizer.

Using the Carpet Glide

What is the Carpet Glide?

The carpet glide enables the Floor Sanitizer to freshen, deodorize and sanitize carpet- ing, rugs, upholstery, pet cushions and more. Used with the Floor Sanitizer it kills dust mites and other allergens on a variety of surfaces.

NOTE: The Carpet Glide is used WITHOUT the Ultra-Microfiber Pad.

To Remove

1

TAB

TAB

2

3Carpet Glide

“Hands Free”

Removal Tab

Attach carpet glide by placing unit under “tabs” and gently pushing down into place.

With carpet glide attached, place on Floor Protector / Resting Mat. Turn unit ON and follow operat- ing instructions to clean.

Turn unit OFF, let cool. Use foot on “Hands Free” tab to remove Tray from steam head.

9