Troubleshooting guide
To assist in location possible faults use help guide below.
| BREAKDOWN PHENOMENON | CHECKING | |
| PICTURE | SOUND | |
|
| ||
|
|
| The aerial direction and connection |
| Picture with snow | Noise |
|
|
|
| This is called ghosting which can be minimized |
|
|
| with an outside aerial, and good quality cable |
|
|
| and terminations. Altering the aerial direction |
| Double or Triple Image | Normal | can also minimize this effect. |
|
| ||
|
|
| Electrical interference which can be caused by cars, |
|
|
| motorbikes etc, Fluorescent lamps and dirty |
| Disturb | Noise | insulators on overhead power cables. |
|
| ||
|
|
| 1. Volume Sound mute. |
|
|
| 2. Only 1 speaker has no sound. Press S.STD button to |
|
|
| choose USER mode, then check wether the BALANCE |
|
|
| item value in SOUND menu equal to 0. Adjust the |
| Normal | No sound or 1 | BALANCE item in SOUND menu as you wish in USER |
| speaker no sound | mode. | |
|
| ||
|
|
| Ensure that the power supply is connected to the TV |
|
|
| set and turned on. Also ensure that the TV set is not |
|
| No sound | in "Listen Mode" or that the brightness and contrast |
| No Picture | are not turned down. | |
|
|
| Adjust colour control |
| No colour | Normal volume |
|
|
|
|
|
|
|
| Adjust channel again |
| Scramble | Normal or Weak Volume |
|
|
|
|
|
|
|
| Colour Purity fault which can be caused by moving the |
|
|
| TV set, placing magnets near the TV screen or turning |
|
|
| on/off house hold appliances such as vacuum cleaners |
|
|
| near the TV set. Turn the TV off with the mains power |
| Colour Spot | Normal volume | switch for 15 minutes. When the power is turn on again |
| the TV set will automatically degauss the picture. In | ||
|
| ||
|
|
| server cases leave the TV set turned off over night. |
|
|
|
|
Note:
1.If the fault can not be repaired using the above guide consult with your local authorized service center.
2.The TV set must only be repaired by a qualified registered service person. Never attempt to remove the back cover as the TV set has dangerous voltages in side that may cause a fatally or fire.
3.The cabinet may produce the occasional "snapping sound" This is normal and caused by the materials in the cabinet expanding with room temperature changes.
