Haier DW12-EBM manual Loading the Dishwasher, Turning on the Appliance

Loading the Dishwasher

Turning on the Appliance

Before placing the dishes in the dishwasher, remove the large food particle to the prevent the filter from becoming clogged,which re- sults in reduced performance.

If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed.This will eliminate the need for extra wash cycles.

Pull out the rack to facilitate loading the dishwasher.

How to Use the Lower Rack

We recommend that you place the most difficult to clean items on the bottom rack:pots ,lids,serving dishes and bowls,as shown in the figure to the right.

It is preferable to place serving dishes and lids on the sides of the racks in order to to avoid blocking the rotation of the top spray arm.

-Pots,serving bowls,etc.must always be placed top down.

-Deep pots should be slanted to allow the water to flow out.

-Silverware should be placed in the silverware basket with the handles at the bottom;if the rack has side baskets,the spoons should be locaed individually into he appropriate slots.Especially long utensils should be placed in the horizontal position at the front of the upper rack(see fig. A).

Lower Rack Upper Rack

Load for 12 Standard Settings

Starting a wash cycle￿

-Make sure that the plug for the appliance is inserted into the wall socket.

-Make sure that the water supply is turned on to full pressure.

-Load the dishwasher (see the section entitled,"Loading the Dishwasher").

-Pour in the detergent (see the section entitled,"Salt,Dergent and Rinse Aid").

-Turn the knob located on the right of the control panel in the clockwise direction until the number or symbol for the cycle set ting is aligned with the reference mark(see the section entitled, "Wash Cycle Table").

-Press the ON-OFF button,and the ON-OFF light will turn on.At this point,the wash cycle will begin.

If you forget to load some of the dishes￿

The wash cycle can be interrupted by pressing the ON-OFF button. You can then load additional dishes and turn the appliance back on.The cycle will start where it left off.

At the end of the wash cycle￿

When the knob stops turning and is aligned with a STOP mark (see figure),the cycle has finished.Turn off the appliance using the ON-OFF button,turn off the water supply and open the door of the dishwasher.

Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage.They will also dry better.

STOP

Cancelling or modifying a wash cycle setting￿

Premise:A cycle that is underway can only be modified if it has only been running for a short time.Otherwise, the detergent may have already been used,and the appliance mayhave already drained the wash water If this is the case,the detergent dispenser must be refilled(see the paragraph entitled,"Loading the Detergent").

Press the ON-OFF button,and the ON light will turn off.Rotate the knob in the clockwise direction to the desired cycle setting (see the section entitled.:Starting a wash cycle￿?F.Then, turn the dishwasher back on using the ON-OFF button.

How to Use the Upper Rack

The upper rack is designed to hold more delicate and lighter dishware,such as glasses,coffee and tea cups and saucers,as well as plates,small bowls and shallow pans (as long as they are not too dirty).

Position the dishes and cookware so that they do not get moved by the spray of water.

The upper rack can be adjusted for height by using the knobs lo- cated on the sides of the rack itself(see fig. B).

Normal Daily Load

fig.A

1

2

3

4

fig.B

.5.	GB	.6.
		GB