Haier HDE03WNA user manual Replace the hinge cover as shown in Fig

HDE03WNA-MANUAL 10/22/01 12:17 PM Page 10

English

Reinstallation: (see fig. # 4 and # 5)

1.Remove the lower pivot pin from the bracket of the lower hinge by turning counter clockwise. Move the pin to the opposite hole and tighten.

2.Loosen the screws holding the lower hinge bracket and remove the hinge.

pivot pin

fig. # 4

Bottom hinge

3.Align the holes in the lower hinge bracket to the corresponding holes in the opposite side of the cabinet. Insert and tighten the screws.

4.To install refrigerator door: make the left bottom hole of the refrigerator compartment door fall over the lower hinge axle, move door forward to make it straight and in alignment with central hinge. Install the central hinge again, turn the hinge axle until it completely enters the door body, then fix it with screws.

Central hinge axle

fig. # 5

Central hinge pad

5.To install freezer door: make the left bottom hole of freezer door fall over the central hinge axle; raise upper hinge, so that hinge axle can be installed in the upper hole of the upper part of the freezer door; adjust door to make it straight and level.

6.As shown in Fig. 1, install the upper freezer hinge to the left corresponding position. (tighten the screws of upper hinge)

7.Replace the hinge cover as shown in Fig. 1.

9