Defrosting/Cleaning
Defrosting
The surface of evaporator ices up when the refrigerator is working. When the frost layer is thick as 3mm, the refrigerator must be defrosted and cleaned. Otherwise, it may results in lower efficiency and high energy consumption.
Set the temperature at ‘0’ position. After defrosting, dry the water tray and then replace it in the refrigerator. Reset the temperature regulator to its original position.
Note: Never use a sharp or pointed item to defrost or loose the ice tray. Otherwise it’s likely to damage the surfaces of the evaporator and result in the leakage of refrigerant. The manufacturer takes no responsibility for cost of the reparation even the appliance is under warranty.
When a power failure is announced
No defrosting
Set the temperature regulator to the highest setting.
No more fresh foods are to be stored in the refrigerator.
Power failure
Do not open the door more often than necessary.
For a power failure not more than 3 hours, foods in the refrigerator can be well stored even in summer.
Moving the refrigerator
Unplug the appliance
Take out foods and dry the water tray before moving the refrigerator.
Note: Do not hold the refrigerator by its door and the piping of
.8.
