Haier HSU-18CV03(T3), HSU-24CV03(T3) operation manual Timer On-Off Operation

Operation

Timer On-Off Operation

Remote Controller

FRESH

STERILIZE

Set clock correctly before starting TIMER operation.

1.After unit starts, select your desired operation mode Operation mode will be displayed on LCD.

2.Timer mode selection

Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows:

Remote controller:

BLANK

TIMER ON TIMER OFF TIMER ON-OFF

Then select your desired TIMER mode (TIMER ON - OFF).

""will flash. 3.Time setting

Press HOUR button.

Every time the button is pressed, time setting increases 1 min, if kept depressed, it will increase rapidly.

Every time the button is pressed, time setting decreases 1 min, if kept depressed, it will decrease rapidly.

It can be adjusted within 24 hours.

4.Timer confirming for TIMER ON

After setting correct time, press TIMER button to confirm

"" on the remote controller stops flashing.

" " starts flashing.

Time displayed: Unit starts or stops at x hour x min.

5.Time setting for TIMER OFF

Just press HOUR button ,follow the same procedure in "Time setting for TIMER ON"

6.Time confirming for TIMER OFF

After time setting,press SET button to confirm. " " on the remote controller stops blinking. Time displayed:Unit stops at x hour x min.

To cancel TIMER mode

Just press TIMER button several times until TIMER mode disappears.

According to the Time setting sequence of TIMER ON or TIMER OFF, either Start-Stop or Stop-Start can be achieved.

17