Problems with clothes:
*Clothes become excessively creased: this is due to improper sorting, overloading or washing in excessively hot water repeatedly. Avoid overloading and resort your load.Wash in cooler water.
*Soap residue: detergent may not be dissolved in water.
*Check water temperature, add detergent as wash tub is being filled with water. Reduce detergent dosage or
*Spots or stains on your clothes: this is due to incorrect use of fabric softener. Refer to manufacturers instructions on the container and follow directions.
*Clothes are grayed or yellowed: this may be due to not using
sufficient detergent for large loads.Add more detergent to the load.
*Clothes are ripped & have holes/excessive wear & tear: this may be due to sharp objects left in washing. Remove all small loose sharp objects, fasten belts, zippers, metal snaps etc. Check if you are using undiluted bleach. Never add undiluted bleach to wash.
LED Display Notes:
Trouble Codes | Reasons | |
Rinse and spin indicators flash | Unit does not drain, or the speed of draining is too slow. | |
|
| |
All progress indicators flash | The washer is out of balance. Please open the lid | |
and rebalance the load. | ||
| ||
All load size (water level ) indicators | The water inlet time exceeds the preset time. | |
flash | ||
| ||
|
| |
“Small” and “Extra Small” load size | Water overflow protection. | |
(water level) indicators flash | ||
| ||
|
| |
“Super” and “Large” load size | The water level sensor fault - Call service. | |
(water level) indicators flash | ||
| ||
|
| |
Beeps | Top lid not close properly. | |
|
|
INSTALLATION INSTRUCTIONS
Tools and Materials Required
You will need to have following tools to help you
with the installation of your washer:
Pliers, Wrench,Tape Measure,Gloves,Level
10
