Haier XPB62-0613D instruction manual How to Install

How to Install

1) Install the Washing machine in a well-ventilated, safe place. Machine should be put on flat ground and where can you connect the power supply. It is recommended to place the washing machine on a leveled floor and avoid a place where the washing machine can be exposed to direct sunlight.

2) Insert the power plug firmly into the main power supply.

3)Water supply in the inlet hose can be adjusted to Wash Tub or Spin Tub.

4) The feeding water indicator -

When the water spills out of the hole above the label, it means too much water has been supplied. Adjust the water tap.

5) Pull out the drain hose from the washing machine. When using the machine for the first time, you may find water remaining in the drain hose. It was used for the factory performance test. It does not imply any malfunction.

Preparation for Washing

1.The machine should be put on Flat Ground.

2.Ensure Three Core Power Plug seat must have Ground Connection.

3.Lay down the Drain Hose.

4.Connect the water Inlet Hose to Water Tap.

5.Remove objects like coins, pins etc., from clothes before washing. They may damage your clothes and clog the drain system.

6.According to the weight of cloth, adjust the level of water.

7.Switch ON power.

How to Wash

1.Set the wash selector knob to "Heavy or Normal".

2.Fill the tub with water according to the weight of cloth (Refer table 1 and 2).

3.Put the clothes in the tub. Do not put an excessive amount of laundry, in the tub. (Refer table 1 and 2).

4.Put recommendable quantity of detergent as mentioned in Table 1.

5.Set Wash Time upto 15min, depending on your cloth load & type (Refer Table 2)

6.When washing is completed, drain off the washing water by adjusting the knob to "DRAIN" position

7.After the washing water is discharged, turn the knob switch to "HEAVY / NORMAL" position.

8.Fill the water up to the desired level for rinsing.

Table 1: Detergent Guide

WASH LOAD	3.0 Kg	3.0~4.5 Kg	4.5~6.2 Kg	6.2 Kg or ABOVE
Water Level	LOW	Medium	High	Over Flow
Amount of Detergent	45 gm	55 gm	65 gm	70 gm
Amount of concentrate Detergent	30 gm	35 gm	40 gm	45 gm
Amount of Softener	25 ml	30 ml	35 ml	40 ml

Note : Actual quantities of load may vary depending on the material size of laundry items.

Note : If movement of cloth is too slow, remove some of the cloth until a steady movement is observed.

Table 2: Laundry Guide

Less than 3.0 kg
	NORMAL	HEAVY	HEAVY
3.0	~ 4.0 kg		10-15 minutes
		HEAVY	HEAVY
	NORMAL
4.0 ~ 5.0 kg		10-15 minutes
	NORMAL	HEAVY	HEAVY
	Wash 0-15 minutes
5.0 kg and above
	NORMAL	HEAVY	HEAVY

RINSING :

1.Fill the water up to desired level depending on cloth load.

2.Set WASH TIMER to 5 ~ 10 min. position to RINSE.

3.When you finish rinsing, drain off the water from the tub by turning the knob to “DRAIN” position. Transfer clothes to Spin Tub for Spinning.

Spin Shower Rinsing

With spin shower, the remaining detergent in the clothes will be removed and you can save on additional rinsing time and water. (However, if water from the tap contains rust and / or dirt, do not perform spin shower.)

Direct water to spin tub by fixing inlet hose to spin water inlet.

3. Turn OFF the tap and then spin for about 1 ~ 5 minutes.

5 6