840141000 v06.qxd 9/26/05 1:57 PM Page 2
IMPORTANT SAFEGUARDS
1.Read all instructions.
2.Blades are sharp; handle carefully.
3.Do not use a broken, chipped, or cracked blender jar.
4.Do not use broken, cracked, or loose blades.
5.Never place cutting unit blades on base without jar properly attached.
6.Screw on jar nut firmly. Injury can result if moving blades acci- dentally become exposed.
7.If jar should turn when motor is turned on, turn off immediately and tighten jar in threaded jar nut.
8.Do not blend hot foods or liquids in the jars. Pressure will build up in the jars and hot liquid will spurt out when opened.
9.Observe the MAX fill line. Do not fill jar above this line.
10.Do not store jars with cutting assembly in place. Remove cutting assembly and wash after each use.
SAVE THESE INSTRUCTIONS!
How to Use
IMPORTANT: Your Hamilton Beach Stay or Go™ Personal Blending Jar and cutting blades are subject to wear during normal use. Always inspect jar for nicks, chips, or cracks. Always inspect cutting blades for broken, cracked, or loose blades. Do not use damaged jar or cutting blades.
Call our
1.Make sure blender is unplugged. Place blender
base on clean, dry surface to keep foreign particles from being pulled up into motor during operation.
2. Place ingredients in personal blending jar. Do not exceed MAX Fill Line. (Illus. 1)
(Illus. 1)
2
3.Place cutting blades in jar nut. Fit gasket over blades. (Illus. 2)
4.Set cutting assembly on top of jar and screw on jar nut. Make sure the jar nut is firmly screwed onto the jar. If not, it may loosen later when motor is turned on. (Illus. 3)
5.Set personal blending jar in place on blender base, making sure it is securely seated. Plug cord into outlet. Follow the instructions provided with your blender for operation. (Illus. 4)
NOTE: ALWAYS turn blender off and wait until blades have stopped rotating before removing jar.
6.Remove personal blending jar from base after blending by lifting straight up. NOTE: NEVER replace jar onto unit while motor is running.
7.Invert personal blending jar so that the cutting assembly is on top of the jar. Unscrew cutting assembly then remove the jar nut, cutting blades and gasket.
8.Screw lid on jar. (Illus. 5)
(Illus. 2)
(Illus. 3)
(Illus. 4)
(Illus. 5)
3
