Caring for the Blender
Troubleshooting Guide
Problem . . . | Solution . . . | |
|
|
|
Blender fails to start | • Check to see if unit is securely plugged into an electric outlet. | |
or stops while it is | • Check to see if the fuse for the electric outlet has blown or if a | |
running and cannot | circuit breaker has tripped. | |
be restarted |
|
|
|
| |
Ingredients will not mix | • Check to see if enough liquid has been added to the ingredients. Mixture should | |
properly | be fluid and | |
| • Solid pieces are too large. Pieces should not exceed 1″ (2.5 cm) cubes. | |
| • Container is too full. Do not fill past highest graduation marking. | |
| • Cutter unit blades are not sharp or are damaged. Inspect container and cutter | |
| assembly daily. Replace container and cutter assembly at least every 12 months | |
| or sooner if cutter assembly appears worn or damaged. | |
| • Check to see if cutter unit assembly is installed properly. | |
| • Select speed (on some models) to create a fluid blend. | |
|
|
|
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily | Unplug the blender and remove the container from the base, and then inspect the container and |
| cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary. If the |
| cutter assembly blades are loose, discontinue use immediately and replace the cutter assembly. |
| Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts” below. |
Weekly | Unplug the blender, and then inspect the power cord insulation and power plug for cracks. |
| Refer to “Requesting Assistance or Service” for repair or replacement. |
Yearly | Replace the container and cutter unit assembly at least once a year. See “Replacement Parts” |
| below. |
|
|
Replacement Parts
Refer to “Requesting Assistance or Service” to order parts below.
Model | Part Description | Part Number | |
|
|
|
|
901 | 1 container |
| |
908 | 1 container |
| |
909 | 1 container |
| |
910 | 1 container |
| |
918 | 1 container | 98000 |
|
919 | 1 container | 98100 |
|
ALL | Cutter unit assembly | 99100 |
|
|
|
|
|
8