must understand that common sense and caution are factors, which cannot be
built into this product, but must be supplied by the operator.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1. MAINTAIN A SAFE WORKING ENVIRONMENT. Keep the work area well lit.
Make sure there is adequate surrounding workspace. Always keep the work
area free of obstructions, grease, oil, trash, and other debris. Do not use the Tile
Saw in excessively damp or wet areas or in areas near flammable chemicals,
dusts, and vapors.
2. PROPER TILE SAW LOCATION: Make sure the Tile Saw is located on a flat,
level, sturdy, surface capable of supporting the weight of the Tile Saw, the
workpieces, and all additional tools and accessories.
3. GROUND THIS PRODUCT. The electrical Power Cord (part #11) for this prod-
uct is equipped with a grounded, 3-Prong Plug. Never remove the grounding
prong or modify the Plug in any way. Do not use adapter plugs with this product.
To comply with the National Electric Code, and to provide additional protection
from the risk of electrical shock, this product should only be connected to a 120
Volt, 3-hole electrical outlet that is protected by a Ground Fault Circuit Interrupter
(GFCI).
4. DO NOT ABUSE THE POWER CORD. Do not use the Power Cord (part #11) to
pull its Plug from an electrical outlet. Keep the Power Cord away from heat, oil,
sharp edges, and moving parts. Route the Power Cord safely. Do not route the
Power Cord where it can be walked on or tripped over. Replace a damaged
Power Cord immediately.
5. IF AN EXTENSION CORD (not provided) IS USED, MAKE SURE TO USE
ONLY UL APPROVED CORDS HAVING THE CORRECT GAUGE AND
LENGTH. (See Figure A.)
REQUIRED MINIMUM EXTENSION CORD GAUGE – 120 VOLT
NAMEPLATE
AMPERES
(
At Full Load
)
EXTENSION CORD LENGTH
0 - 25
Feet
25 - 50
Feet
50 -100
Feet
100 – 15
0
Feet
150– 200
Feet
0 - 5 16 16 16 12 12
5.1 - 8 16 16 14 10 -
8.1 - 12 14 14 12 - -
12.1 - 15 12 12 10 - -
15.1 - 20 10 10 10 - -
FIGURE A
SKU 03733 PAGE 4