Page 4SKU 1541 for technical questions, please call 1-800-444-3353.
Attach the Steering Assembly (G) to the Turntable (D) using a Bolt (3), Flat
Washer (10), Spring Washer (9), and Nut (8). Slide the Bolt through the under-
side of the Steering Assembly (B) and into the Turntable. Secure it from inside
the Turntable with the hardware. Loosely thread the Nut onto the Bolt. Insert the
Cotter Pin through the hole and spread it open.
Attach both parts to the Bed. Insert four Bolts (1) from the top of the wagon
down and tighten in place on the bottom of the Bed with four Washers (10), Lock
Washers (9) and Nuts (8).
Slide each of the four Wheels (C) onto an axle with the Air Valve facing out.
Slide a 1-1/4” Washer (11) onto each axle on the inside the Wheel, and attach
the Cotter Pin to the outside of the Wheel. Spread the cotter pin out to secure
the Wheel.
Attach each of the four Axle Caps (13) to the Axles.
Insert the lower part of the Handle (B) into the Steering Assembly. Slide the Bolt
(2) into the Assembly and through the Handle so that it exits the other side of the
Assembly. Tighten the Bolt into place with a Washer and the Nut Cap (7).
Turn the Wagon upright and roll it around, turning the handle to assure smooth
and efcient operation.

operating inStructionS

read the entire iMportant Safety inforMation section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Turning the Handle will turn the front wheels on the wagon. The Handle can be
raised for steering from inside the wagon, or lowered so that the wagon can be
pulled.
Always park the Wagon on a at, level surface.

Maintenance and SerVicing

damaged equipment can fail, causing serious personal
injury. do not use damaged equipment. if abnormal noise
or vibration occurs, have the problem corrected before
further use.
Before eacH uSe, inspect the general condition of the Wagon. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts
and any other condition that may affect its safe operation.
Check the air pressure for the tires before each use and inate as necessary.
Do not exceed the maximum 30 PSI. Oil the wheels periodically.
after uSe, clean external surfaces of the tool with clean, moist cloth.
3.
4.
5.
6.
7.
8.
1.
2.
1.
2.
3.
warningwarning