Harbor Freight Tools 2448 operating instructions Air Connection, Operation

7.Fit Suction Hose [1] over the Vacuum Body with Air Switch Assembly [10].

8.To connect the Hose to an Abrasive Blast Cabinet (not included), unscrew the Connecting Nut [2-2] and remove the O-Ring [2-1]. Fit the Connecting Hose [2] into the 1-1/4” Dia. outlet in the Blast Cabinet. Reaffix the O-Ring and the Connecting Nut to the Hose from the inside of the Blast Cabinet. Be sure the Hose is tightly connected before use.

Air Connection

DUST

COLLECTOR

Note: Air Compressor is not supplied.

1.You will need to prepare a 1/2” Air Connector (not included with this product) and connect it to the valve located on the Vacuum Body with Air Switch Assembly.

2.Wrap the Air Connector with a pipe thread seal tape before connecting to a 3/8” I.D. Air Source Hose (not included). Connect the Air Source Hose to the Valve.

3.Air pressure should not exceed 125 psi.

This air powered product requires lubrication during operation. For best results, it is recommended to have an oiler and water filter in line with the air supply as shown. This will extend the life of the product.

Operation

The product is intended for use with a 10-60 gallon Abrasive Blast Cabinet (not included). Read all instructions for Operating the Sand Blast Cabinet before using this product.

1.Follow instructions in Step 8, above, for connecting the Hose to the Sand Blast Cabinet.

2.Connect the Dust Collector to the Air Compressor according to the instructions on Page 5, “Air Connection.”

3.Use the Air Switch attached to the Air Switch Assembly to control the amount of air flow through the product. Air Compressor pressure should not exceed 125 psi.

SKU 2448 Page 5