Step 7) | Attach each of the four (4) Axle Caps (from Bag part K) to the Axles. |
Step 8) | Insert the lower part of the Handle (part B) into the Steering Assembly (part J). |
| Slide the |
| exits the other side of the Assembly. Tighten the Bolt into place with a Small |
| Washer and Nut Cap. |
Step 9) | Turn the Wagon upright. Attach one (1) of the Long Side Panels (part E) to the |
| wagon with the three (3) |
| The top of the Bolts should be on the inside of the Tray. Tighten each into place with a |
| washer then a Nut Cap. |
Note: | The Short Front Panel (part G) is the one with a downward curved front slat. |
Step 10) | Attach the Short Rear Panel (part F) to the wagon with two (2) |
| through the Tray (A) and each vertical slat. Tighten into place by sliding on the |
| washer followed by the Nut Cap. |
Step 11) | Attach the second Long Side Panel (part E) as in step 9. Attach the Short Front |
| Panel (part G) with two (2) |
| Nut Cap as previously described. |
| Operation |
Your Wagon has a long handle mounted at the front. Use the handle to pull the wagon to your destination, as well as transporting loads to and from your destination.
Turning the Handle (part B) will cause the front wheels on the wagon to turn. Turn the Handle in the direction that you wish the wagon to go. The Handle can be raised for steering from inside the wagon, or lowered so that the wagon can be pulled from in front.
if there is any question about a condition being safe or unsafe, do not operate the Wagon.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THat ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
#32826 | REV 02g | Page 4 |
