![](/images/new-backgrounds/1210001/2100017x1.webp)
20.KEEP GUARDS IN PLACE. All guards and fences need to be in proper working order and alignment. Check before every use.
21.NEVER LEAVE TOOL RUNNING UNATTENDED. Always turn off power. Do not leave tool until it comes to a complete stop.
22.BE CAUTIOUS WHEN SANDING WOOD THEN METAL. Combining wood dust and metal filings can create a fire hazard. Always clean away any wood dust before attempting to use the sander on metal products.
23.MAINTAIN A CLEARANCE OF 1/16” OR LESS BETWEENTHETABLE ANDTHE SANDING BELT.
24.NEVER WEAR GLOVES OR HOLD THE WORKPIECE WITH A RAG WHEN SANDING.
25.DO NOT SAND PIECES THAT ARE TOO SMALL TO BE SAFELY SUPPORTED OR HELD. Such pieces should be sanded by hand.
26.WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contains chemicals known [to the State of California] to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
Lead from
Crystalline silica from bricks and cement or other masonry products Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are spe- cially designed to filter out microscopic particles.
(California Health & Safety Code § 25249.5, et seq.)
GROUNDING
WARNING!
Improperly connecting the grounding wire can result in the risk of electric shock. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify the power cord plug provided with the tool. Never remove the grounding prong from the plug. Do not use the tool if the power cord or plug is damaged. If damaged, have it repaired by a service facil- ity before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician.
REV 12/06
SKU 34951 | For technical questions, please call | Page |