ADJUSTMENTS
1.To increase the gap between SHAFT I (#17) and SHAFT II (#18) to allow for varying thickness of materials, screw out the ADJUSTMENT KNOB (#24). To decrease the gap, screw it in. Make sure to adjust both KNOBS an equal amount. See Figure 1.
2.To increase the gap between SHAFT I and SHAFT III (#8) to increase the diameter of your rolls, screw out the ADJUSTMENT KNOB (#4). For smaller diameter rolls, screw the KNOB in. For even rolls, adjust both KNOBS an equal amount. To create cones, adjust one side more than the other. See Figure 2.
Page 5
