Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that the product is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Operation
Note: When using the Heater for the first few times, an odor may be noticed. The odor is a remnant from the moulding process and will dissipate after several minutes of operation.
Warning!! When not in use and when the vehicle’s engine is OFF, unplug the Heater from the 12 Volt power source.
1.Make sure the vehicle engine is running when operating the Heater.
2.Mount the Heater on the dashboard or any location in your vehicle where you can operate the controls. The Heater comes with a mounting bracket that will allow you to pivot the Heater once it is mounted. The mounting bracket should be separated from the heater by firmly pulling the bracket with one hand while holding the heater in your other hand.
3.Next attach the mounting bracket using screws or the supplied double sided tape.
Note: Before drilling any holes make sure there are no wires or cables in the drilling path.
4.
Note: Make sure the air openings on the Heater are clear of dirt or debris.
5.Insert the 12 Volt plug into the vehicle’s DC power inlet (cigarette lighter).
6.Turn the switch on the side of the unit to FAN or HEAT position. The Fan setting blows air only. The HEAT setting blows out heated air.
Warning! Do not operate the unit for more than
7.When finished, turn the switch to “OFF” and unplug the unit.
SKU 36711 | For technical questions, please call | Page 4 |
